Official Tamiya Lunchbox & Midnight Pumpkin Picture Thread
01-16-2007, 12:20 PM
#52
Senior Member
Thread Starter
Join Date: Nov 2006
Location: Stockton-on-TeesEngland, UNITED KINGDOM
Posts: 5,476
Likes: 0
Received 0 Likes
on
0 Posts
RE: Official Tamiya Lunchbox & Midnight Pumpkin Picture Thread
nice wheels there broncojd, hmm...[&:] they look familliar lol
01-16-2007, 12:25 PM
#54
Senior Member
Thread Starter
Join Date: Nov 2006
Location: Stockton-on-TeesEngland, UNITED KINGDOM
Posts: 5,476
Likes: 0
Received 0 Likes
on
0 Posts
RE: Official Tamiya Lunchbox & Midnight Pumpkin Picture Thread
what were them things that you put onto the front onesto stop the movement?
01-16-2007, 12:34 PM
#56
Senior Member
Thread Starter
Join Date: Nov 2006
Location: Stockton-on-TeesEngland, UNITED KINGDOM
Posts: 5,476
Likes: 0
Received 0 Likes
on
0 Posts
RE: Official Tamiya Lunchbox & Midnight Pumpkin Picture Thread
yeah but i was wodering where you got the gold bit from?
01-16-2007, 12:39 PM
#57
Join Date: Nov 2005
Location: Dallas,
TX
Posts: 1,246
Likes: 0
Received 0 Likes
on
0 Posts
RE: Official Tamiya Lunchbox & Midnight Pumpkin Picture Thread
they're oilite bushings that i took out of my stampede when i installed ball bearings i the wheels. there is also one used in the lunchbox, but only one. if you used ball bearings when you built it, you should have it leftover.
hpi makes an adapter set, too. tower has them for $1.90. maybe you could find them at a local shop? (the link is posted in the other thread)
hpi makes an adapter set, too. tower has them for $1.90. maybe you could find them at a local shop? (the link is posted in the other thread)
01-16-2007, 12:42 PM
#58
Senior Member
Thread Starter
Join Date: Nov 2006
Location: Stockton-on-TeesEngland, UNITED KINGDOM
Posts: 5,476
Likes: 0
Received 0 Likes
on
0 Posts
RE: Official Tamiya Lunchbox & Midnight Pumpkin Picture Thread
i have go amost all the play out of it by putting a small hex peice on, then 2 plastic bearings, then rim, then plasics bearing, then nut, i only have maybe 1-3mm of play left
01-16-2007, 01:07 PM
#60
Senior Member
Thread Starter
Join Date: Nov 2006
Location: Stockton-on-TeesEngland, UNITED KINGDOM
Posts: 5,476
Likes: 0
Received 0 Likes
on
0 Posts
RE: Official Tamiya Lunchbox & Midnight Pumpkin Picture Thread
for my box?
no lol, i bought if from some shopping mall type thing about an hours drive away from me for $160, and didn't even think of buying them for about 2-3 months after until i found RCU and LB's thread lol, i will buy them with my next order, aswell as some of them tyres and a new reciver, i broke one of the pins off my 'box one tonight lol
no lol, i bought if from some shopping mall type thing about an hours drive away from me for $160, and didn't even think of buying them for about 2-3 months after until i found RCU and LB's thread lol, i will buy them with my next order, aswell as some of them tyres and a new reciver, i broke one of the pins off my 'box one tonight lol
01-17-2007, 05:26 PM
#61
Senior Member
Join Date: Dec 2006
Location: Nuremberg, GERMANY
Posts: 997
Likes: 0
Received 0 Likes
on
0 Posts
RE: Official Tamiya Lunchbox & Midnight Pumpkin Picture Thread
Some short videos I took:
[link=http://www.youtube.com/watch?v=qZji2HEaSYQ]Livingroom Lunchbox Part 1[/link]
[link=http://www.youtube.com/watch?v=tjj9ZXBv8o0]Livingroom Lunchbox Part 2[/link]
[link=http://www.youtube.com/watch?v=hxMHDPGkPDM]Livingroom Lunchbox Part 3[/link]
Hope you like em, though not the natural environment for the 'Box...
01-17-2007, 05:43 PM
#63
Senior Member
Join Date: Dec 2006
Location: Nuremberg, GERMANY
Posts: 997
Likes: 0
Received 0 Likes
on
0 Posts
RE: Official Tamiya Lunchbox & Midnight Pumpkin Picture Thread
Tamiya Super Stock TZ. Quite cheap, 23 Turns, but very powerful!
[link]http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXGYR9[/link]
Specs:
R.P.M. at best efficiency: 26,500rpm (7.2V)
Torque at best efficiency: 500g-cm (7.2V)
[link]http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXGYR9[/link]
Specs:
R.P.M. at best efficiency: 26,500rpm (7.2V)
Torque at best efficiency: 500g-cm (7.2V)
ORIGINAL: lee172
looks manic! what motor you got in there?
looks manic! what motor you got in there?
01-17-2007, 06:26 PM
#64
Join Date: Sep 2006
Location: Midlands, UNITED KINGDOM
Posts: 8,217
Likes: 0
Received 0 Likes
on
0 Posts
RE: Official Tamiya Lunchbox & Midnight Pumpkin Picture Thread
oh well, i aint far behind!
18,300 rpm at best efficiency
350 g-cm torque at 18,300 rpm
the good old trusty sport tune!
not bad for nearly 4 times cheaper!
18,300 rpm at best efficiency
350 g-cm torque at 18,300 rpm
the good old trusty sport tune!
not bad for nearly 4 times cheaper!
01-19-2007, 03:15 PM
#66
Join Date: Nov 2005
Location: Dallas,
TX
Posts: 1,246
Likes: 0
Received 0 Likes
on
0 Posts
RE: Official Tamiya Lunchbox & Midnight Pumpkin Picture Thread
will you take a picture of it with the body off? i'd like to see what you did with the rear body mounts...
looks good!
looks good!
01-19-2007, 05:14 PM
#69
Senior Member
Thread Starter
Join Date: Nov 2006
Location: Stockton-on-TeesEngland, UNITED KINGDOM
Posts: 5,476
Likes: 0
Received 0 Likes
on
0 Posts
RE: Official Tamiya Lunchbox & Midnight Pumpkin Picture Thread
looks nice, are the posts any better that the sock box ones?
01-21-2007, 05:05 AM
#72
Senior Member
Thread Starter
Join Date: Nov 2006
Location: Stockton-on-TeesEngland, UNITED KINGDOM
Posts: 5,476
Likes: 0
Received 0 Likes
on
0 Posts
RE: Official Tamiya Lunchbox & Midnight Pumpkin Picture Thread
thanks lee1092, yes but the sad thing is that he has posted it in every thread i have posted in lol
01-22-2007, 12:31 PM
#73
Senior Member
Thread Starter
Join Date: Nov 2006
Location: Stockton-on-TeesEngland, UNITED KINGDOM
Posts: 5,476
Likes: 0
Received 0 Likes
on
0 Posts
RE: Official Tamiya Lunchbox & Midnight Pumpkin Picture Thread
here are some pix of my 'box after driving down the beach yesterday
01-23-2007, 11:59 PM
#74
Join Date: Nov 2005
Location: Dallas,
TX
Posts: 1,246
Likes: 0
Received 0 Likes
on
0 Posts
RE: Official Tamiya Lunchbox & Midnight Pumpkin Picture Thread
props to dante777 for getting on the front page of rcuniverse...
[link=http://i58.photobucket.com/albums/g240/broncojd/dante_frontpage.jpg]http://i58.photobucket.com/albums/g240/broncojd/dante_frontpage.jpg[/link]
i uploaded so it will be available to be seen after i get around to taking it out of photobucket. but for now you can open the link and download the big pic from there.
looks cool!
[link=http://i58.photobucket.com/albums/g240/broncojd/dante_frontpage.jpg]http://i58.photobucket.com/albums/g240/broncojd/dante_frontpage.jpg[/link]
i uploaded so it will be available to be seen after i get around to taking it out of photobucket. but for now you can open the link and download the big pic from there.
looks cool!
01-24-2007, 03:16 AM
#75
Senior Member
Join Date: Dec 2006
Location: Nuremberg, GERMANY
Posts: 997
Likes: 0
Received 0 Likes
on
0 Posts
RE: Official Tamiya Lunchbox & Midnight Pumpkin Picture Thread
At least someone noticed it...
Yes, can't believe I made it there! Thanks for posting.
ORIGINAL: broncojd
props to dante777 for getting on the front page of rcuniverse...
[link=http://i58.photobucket.com/albums/g240/broncojd/dante_frontpage.jpg]http://i58.photobucket.com/albums/g240/broncojd/dante_frontpage.jpg[/link]
i uploaded so it will be available to be seen after i get around to taking it out of photobucket. but for now you can open the link and download the big pic from there.
looks cool!
props to dante777 for getting on the front page of rcuniverse...
[link=http://i58.photobucket.com/albums/g240/broncojd/dante_frontpage.jpg]http://i58.photobucket.com/albums/g240/broncojd/dante_frontpage.jpg[/link]
i uploaded so it will be available to be seen after i get around to taking it out of photobucket. but for now you can open the link and download the big pic from there.
looks cool!
