RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Search
Today's Posts
Mark Forums Read
Vendor Directory
Notices
Search: Posts Made By: JSF-TC
Showing results 1 to 7 of 7
Search took 0.01 seconds.
Forum: RC Jets
09-18-2020, 05:31 AM
Replies: 554
Views: 87,753
Posted By JSF-TC

I make a mounting plate for my gyro or Assist Rx...

I make a mounting plate for my gyro or Assist Rx from 1/8" ply to which I CA a thin layer of G10 or Fliteskin, to act as the smooth surface for the double sided tape. I then screw this mounting plate...
Forum: RC Jets
09-03-2020, 08:42 AM
Replies: 554
Views: 87,753
Posted By JSF-TC

No need for a mix, just map the steering servo to...

No need for a mix, just map the steering servo to the rudder stick, and then use dual rates. 0% for gear up.


Paul
Forum: RC Jets
08-18-2020, 08:01 PM
Replies: 554
Views: 87,753
Posted By JSF-TC

OK, still struggling a bit with the Assist with...

OK, still struggling a bit with the Assist with assignment of gain control using the transmitter Gyro Settings page, but I think I found a way to do it.

I have assigned 3 flight modes (Flaps Up,...
Forum: RC Jets
08-17-2020, 12:49 PM
Replies: 554
Views: 87,753
Posted By JSF-TC

Mark, I have not installed the Assist yet...

Mark,

I have not installed the Assist yet and I'm still playing with it to get familiar, but I don't see why the same approach as used on the Cortex wouldn't work with the Assist, using the...
Forum: RC Jets
08-17-2020, 11:40 AM
Replies: 554
Views: 87,753
Posted By JSF-TC

Mark, On my current Cortex/ Cortex Pro...

Mark,

On my current Cortex/ Cortex Pro models, I calibrate with flaps up and have the gain on my Flight Mode switch. While I may have 20-30% gain with flaps up, I have around 70% with take off...
Forum: RC Jets
08-17-2020, 11:23 AM
Replies: 554
Views: 87,753
Posted By JSF-TC

Wayne, Thanks for the information. Again,...

Wayne,

Thanks for the information. Again, not described in any official documentation.

With that new info, I did some more investigations on the bench.

At no time in Normal (Damping) Flight...
Forum: RC Jets
08-17-2020, 08:27 AM
Replies: 554
Views: 87,753
Posted By JSF-TC

I'm just starting to play with an Assist prior to...

I'm just starting to play with an Assist prior to installing in my next project and looking for some clarification on the Damping Only (allows trims and butterfly) menu item.

Coming from Cortex/...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.