need help wiring speedcontrols for hummingbird
#2
Senior Member
Join Date: Oct 2003
Location: fairport,
NY
Posts: 168
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.rcuniverse.com/forum/images/icons/icon1.gif)
solder the postive wires from both esc's together, and the negatives together, then put a connector on them like you normally would
#5
Member
Join Date: Oct 2004
Location: , NETHERLANDS
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.rcuniverse.com/forum/images/icons/icon1.gif)
of course not... one goes to channel 3 for throttle and one goes to channel 4 for rudder (typical setup). If im not mistaken, you can just send the signal wire from the tail esc to the RX and not all three since the main motor esc will power the RX.
#6
Junior Member
Join Date: Dec 2002
Location: Brooklyn,
NY
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.rcuniverse.com/forum/images/icons/icon1.gif)
I thought the tail esc goes to the gyro output and the gyro input to channel 4 of rec.
Do a search on seperates i did see a complete explanation some where.
Do a search on seperates i did see a complete explanation some where.
#7
Junior Member
Join Date: Dec 2002
Location: Brooklyn,
NY
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.rcuniverse.com/forum/images/icons/icon1.gif)
Im sorry it was another site I saw the seperate electronicshookup: http://www.helihobby.com/html/separate_electronics.html