T18SZ RF Off
#1
Junior Member
Thread Starter
Join Date: Jul 2021
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
T18SZ RF Off
Hi,
I'm trying to setup a helicopter model in an 18SZ but cannot get past the power up screen. The radio just keeps beeping and the screen shows rf off. I have the throttle down so that warning is gone. If a switch is set wrong I can not figure out what it is. When setting up a plane, it works fine. I can link to a R7008SB and move servos connected to it.
Any help would be greatly appreciated.
Thanks,
Jeff
I'm trying to setup a helicopter model in an 18SZ but cannot get past the power up screen. The radio just keeps beeping and the screen shows rf off. I have the throttle down so that warning is gone. If a switch is set wrong I can not figure out what it is. When setting up a plane, it works fine. I can link to a R7008SB and move servos connected to it.
Any help would be greatly appreciated.
Thanks,
Jeff
#2
Junior Member
Thread Starter
Join Date: Jul 2021
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
I finally figured it out. I was able to find where the switch settings are defined and was able to set all the switches off and now it works. I was then able to track down that switches E and G were on and that is what kept the radio from working.