TM-8 FAAST module config and binding
09-19-2023, 09:24 AM
#1
Thread Starter
Join Date: Aug 2010
Location: Brussels, BELGIUM
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
TM-8 FAAST module config and binding
Hi,
I am trying to use a Futaba TM-8 module with my various FAAST RX's.
I have configured the radio (openTX) to PPM 22.5ms 300u Frame.
This allows be to bind to a variety of my FAAST rx's but not to some. Is there any way of adjusting to be able to bind to those that fail? In particular a conversion rx that has been added to a Hirobo Quark SG control unit to enable 2.4GHz instead of FM.
Thanks for any advice or tips?
Cheers,
Bob
I am trying to use a Futaba TM-8 module with my various FAAST RX's.
I have configured the radio (openTX) to PPM 22.5ms 300u Frame.
This allows be to bind to a variety of my FAAST rx's but not to some. Is there any way of adjusting to be able to bind to those that fail? In particular a conversion rx that has been added to a Hirobo Quark SG control unit to enable 2.4GHz instead of FM.
Thanks for any advice or tips?
Cheers,
Bob
