Wiring a kill switch on a Zen. G62
#1
Senior Member
Thread Starter
My Feedback: (20)
Join Date: Nov 2003
Location: Lodi,
OH
Posts: 262
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.rcuniverse.com/forum/images/icons/icon1.gif)
I need an explanation or diagram on how to wire a kill switch and a micro switch on a servo for a G62 with a C&H electronic ignition. This setup uses the original coil with the E.I. C&H site seems to be out of service. Thanks, expo
#3
Senior Member
Thread Starter
My Feedback: (20)
Join Date: Nov 2003
Location: Lodi,
OH
Posts: 262
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.rcuniverse.com/forum/images/icons/icon1.gif)
Thanks for the advice. Would it be possible to put the kill switch in line with the wire coming from the coil to the C&H e. i.? The one with the bullet connectors?
#4
Senior Member
My Feedback: (4)
Join Date: Jul 2002
Location: Somewhere,
DC
Posts: 9,825
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.rcuniverse.com/forum/images/icons/icon1.gif)
Same result, the engine will stop, but the ignition circuit will still be powered up....Best to interrupt the power...Either red or black...