F86_SABRE

Hi,

I have an ST4500 which has been converted to gas (has needle roller bearings and Walbro carb), however I just bought a PROSPARK unit which has been lying idle for some time and has seen no use but my buddy lost the instruction sheet that came with it.
Is there anybody who can email me a copy of the instruction sheet please? I appreciate taking the time to read this and perhaps assist me too.

With thanks

Reuben
email: [email protected]

Antique

My Feedback: (4)

Don't have the sheet, but Jerry Nelson was a dealer for a while, he might have one...
Do NOT, under circumstance, turn on the ignition or flip the prop without a spark plug in the wire, and touching the ground....The spark will go back into the circuit and blow the whole thing...I have seen it happen....Don't even play around with it to check for spark unless there's a way for the spark to go to ground.....The circuit might have been redesigned, but don't take a chance....

F86_SABRE

RCIGN1,

Thanks for the tip. I will take note of what you said.
I hope that I will find a good soul who can send me these instructions as I will not be mounting the unit unless I have them....for safety reasons.

Thanks

Reuben

TLH101

My Feedback: (90)

ProSpark e-mail and phone number are here:
http://www.nelsonhobby.com/prospark.html

F86_SABRE

Thanks Terry.
Email was returned undelivered because of this:

User's mailbox is full: <[email protected]>
Unable to deliver mail.


[]

Thanks anyway

Reuben