JSingh

Hi Guys, I'm in a process of rebuilding a Jetcat P120, I was trying to figure out the thread size of my Jetcat P120's Nut that holds on the compressor wheel to the shaft. I need to make a new nut for it but I can't figure out the thread size. I know its a left-hand thread and the diameter is 6mm. But I'm having trouble figuring out the thread pitch/size. I was wondering if anyone could help. I don't want to send it to Jetcat as it would take too long and I can balance the turbine myself.

mr_matt

My Feedback: (10)

How do you balance it yourself?

ledd4u

My Feedback: (23)

Can you mark everything carefully and place back? Just asking. I have a popping sound only at idle. From the rear I see the pop at 4-5 o’clock. Been reading a full disassembly is needed to verify the injector isn’t aligned properly.

JSingh

yeah, I believe you could mark everything very precisely then re assemble it and torque everything down like it originally was.

ledd4u

My Feedback: (23)

I would like to find data on the torque specs etc.