Super Sportster 40 MKII Dihedral
#1
Junior Member
Thread Starter
Join Date: Dec 2004
Location: Virginia Beach, VA
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Super Sportster 40 MKII Dihedral
I am joining the wing halves of the Super Sportster MKII Kit. The instructions say that dihedral is not critical but should be approx 1" at each wingtip. Is this 1" from the rounded wingtip itself or 1" from the bottom of the last rib? The wingtip as installed per plans is already about 3/4" from building board. I don't want too much dihedral but don't want it wrong.
Thanks/DaveB
Thanks/DaveB
#2
Junior Member
Join Date: Apr 2006
Location: Hamilton, OH
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
RE: Super Sportster 40 MKII Dihedral
I have the origional Sportser plans and it shows wing panels upside down
with 3/4" space between wing and table at center of wing and the top of outboard ribs touching table.
with 3/4" space between wing and table at center of wing and the top of outboard ribs touching table.