Blackout XTE motor smoked with 2s lipo
#1
Blackout XTE motor smoked with 2s lipo
My son and I each have a Blackout XTE, the gray suv and the red truck. I upgraded both to a 2s Lipo(7.4v 6200mah 80c). I also moved the LVC jumper on both. Both batteries were fully charged.
The red one was always significantly slower in original setup. After installing the 2s, the motor smoked/dead immediately. Steering still works.
Also, the gray suv went like a bat out of hell, but had less run-time than the 3000mah NiMH that came with the trucks. I was under the impression id get at least double the run-time, but only had about half the original.
Any thoughts or help would greatly be appreciated.
The red one was always significantly slower in original setup. After installing the 2s, the motor smoked/dead immediately. Steering still works.
Also, the gray suv went like a bat out of hell, but had less run-time than the 3000mah NiMH that came with the trucks. I was under the impression id get at least double the run-time, but only had about half the original.
Any thoughts or help would greatly be appreciated.
The following users liked this post:
scdlguy (02-16-2020)