trckey2

i think i messed up the rear differential on my RC10T4. any suggestions? it grinds a little when moveing and the tranny is ok cause i toar into it

sleepy23

My Feedback: (1)

clean everything, check the diff balls and the thrust balls. make sure your idler of diff gear doesnt have a buggered up spot.

trckey2

sorry took me so long, had some personal problems, did as you suggested, cleaned it all, problem still there[&o], so i looked at bearings, think i am gonna try replaceing them, towerhobbies dont have them and my LHS was closed when i got there[:@], gonna go back tommorrow and order them, then if that dont work do i rebuild the tranny or use it as an excuse to get a 4wd buggy?

FSTlosiEVR

Didnt know they made a front diff....huh.[sm=surprised.gif]

trckey2

well, they must make front diff some where if it is caled a rear diff in other posts, or maybe other ppl have made the same mistake as me, and maybe just maybe it is called a rear diff cause that is what it is on full scale cars. wierd huh

FSTlosiEVR

Its 2wd.1 diff.

trckey2

thanks for the help, now i know what to say. so what should i do about the problem since you know so much about diffs?

Sanyo15.6v

Take it apart and clean it.Get some goo quality diff grease and make sure not to use to much.