Fusion engine ecrew EZ start ?
#1
Senior Member
Thread Starter
Join Date: Jan 2007
Location: Miami, FL
Posts: 216
Likes: 0
Received 0 Likes
on
0 Posts
Fusion engine ecrew EZ start ?
I strip the EZ start of my Fusion engine. I'm trying to replace the backplate screw(where the hex shaft goes), but I can't figure it out how to take it off. Can someone pls show me how?
#2
Join Date: Jul 2003
Location: indpls, IN
Posts: 3,140
Likes: 0
Received 0 Likes
on
0 Posts
RE: Fusion engine ecrew EZ start ?
Go to the Schumacher site at http://www.racing-cars.com look under forums click on nitro touring then click on upgrades and improvements go to page 2 towards the bottom of the page there is instructions on how to take out the screw. Sorry it did have pictures don't know what happened to them but the verbal instructions explain what you need to do.
#5
Join Date: Jul 2003
Location: indpls, IN
Posts: 3,140
Likes: 0
Received 0 Likes
on
0 Posts
RE: Fusion engine ecrew EZ start ?
ORIGINAL: Schumacher RC Superstore
You need to remove the entire plate. 4 screws and it will all be in your hand.
You need to remove the entire plate. 4 screws and it will all be in your hand.